![]() Use "START/STOP" (front) button to put into "stop" state (mile/h symbol not flashing.) Use "MODE" (top) button to get to "ODO" mode. Settings may be changed in these modes as described below. Pressing the "MODE" button will cycle the computer through the modes: When calibration value "A" is set to desired number, press "SET" (underside) button to accept and put the computer into normal operation. Use "MODE" (top) button to raise calibration number, or "START/STOP" (front) button to decrease it. When total miles/km value is set to desired number, press "SET" (underside) button to accept and enter wheel calibration mode. Press "MODE" (top) button to adjust that digit. Use "START/STOP" (front) button to change which digit is flashing. Press "MODE" (top) button for two seconds to enter "odometer setting" (total km/miles) mode. ![]() Press "MODE" (top) button to select "mph" (miles) or "km/h" (kilometers). Push all three buttons at once ("SET" button is on underside of unit.) Do this to clear the computer's memory after replacing the battery: If these buttons are further held down for more than 3 seconds, the wheel calibration value moves between "A" and "B" values.įor total reset. When the "START/STOP" (left) and "MODE" (right) button are pressed together in "ODO" mode, first the wheel calibration number appears. To select which weel calibration value to use: Press and hold the "SET" button for 2 seconds to switch back and forth between "A" and "B" calibration value. Press the "SET" button with a ballpont pen or similar tool. ![]() Use "START/STOP" button to put into "stop" state (mile/h symbol not flashing.) To revise wheel size without losing mileage: If you hold the "SET" button for 2 seconds or more, you enter the mode to set the alternate ("B") calibration number. When calibration value "A" is set to desired number, press "SET" (recessed) button to accept. Note: This unit permits the entry of two different calibration numbers ("A" & "B") to allow the same computer to be used with different bicycles Use "MODE" (right) button to raise calibration number, or "START/STOP" (left) button to decrease it. When odometer value is set to desired number, press "SET" (recessed) button to accept and enter wheel calibration mode. Press "MODE" (right) button to adjust next digit. Use "START/STOP" (left) button to change flashing digit. Press "MODE" (right) button to enter "odometer setting" mode. Use "START/STOP" (left) button to select "M" (miles) or "Km" (kilometers). Press "MODE" (right) button to enter distance scale selection mode. Push all three buttons at once ("SET" button is recessed on bottom of unit.) Address for service: 2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan Attn.: CAT EYE Customer Service Section Service & Research Address for United States Consumers: CATEYE Service & Research Center 1705 14th St.If you make a note of the odometer reading before changing batteries, you can re-enter the total distance reading after installing the new battery. Insurance, handling and transportation charges to our service shall be borne by person desiring service. Please write or type your name and address clearly on the warranty certificate. To return the product, pack it carefully and remember to enclose the warranty certificate with instruction for repair. ![]() The service must be performed by Cat Eye Co., Ltd. タイヤ周長ガイド(タイヤサイズは通常タイヤの側面に記載されています) LIMITED WARRANTY 1-Year Warranty for Main Unit Only (Accessories/Attachments and Battery Consumption excluded) If trouble occurs during normal use, the part of the Main Unit will be repaired or replaced free of charge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |